Home > Knowledge > Content
How to assure every rare earth (or any) magnet meets your requirements?
Oct 09, 2017

How to assure every rare earth (or any) magnet meets your requirements?

Assure: definition – “make (something) certain to happen.”

So you have designed and thoroughly tested your revolutionary magnetic device and are ready to place an order with your chosen magnet supplier.  How do you assure the magnets you receive will meet your (and your customers) requirements 100% of the time?


Like any engineered product, the first and most important task is to develop a set of documents that provide a detailed and clear definition of your requirements; this includes GD and T drawings, descriptions of all magnetic, mechanical, environmental and thermal specifications and an explanation of test methods including gauges, fixtures and equipment.  It's also useful to include any relevant quality and testing standards. A very important point to make here is that the development of the total magnet specification should be done jointly with the magnet supplier at the earliest time in the application development process. This allows a mutually accepted specification to be developed that meets your requirements while at the same time, by recognizing inherent magnet process limitations, provides the most cost effective solution.


JOC LLC has developed a tool and methodology (REassure™) that utilizes a series of templates describing the 4 essential process quality elements in the magnet manufacturing process.  The elements are; process control, product control, calibration and records. Detailed templates are developed for every process step in the supplier's manufacturing process including sub-suppliers e.g. magnet plating and coating. REassure™ is based on ISO/TS 16949 QMS process audit practices combined with over 30 years’ experience in the magnet industry and automotive supply chain knowledge.

What follows is a example of the REassure™ methodology as applied to a typical rare earth magnet product. The generic process steps for rare earth magnet (NdFeB) manufacturing are shown below:

Magnet Production Processes.png


Generic process for rare earth (NdFeB) sintered magnet

In this example of Reassure™ I will take one process step i.e. milling or fine pulverization by jet milling. The major objective of milling rare earth permanent magnet alloys is to produce a narrow size distribution of single crystal particles, i.e., individual particles containing no grain boundaries and therefore only one preferred axis of magnetization. This step must also be completed with the minimum contamination of the fine powder. There are many types of jet mills used in rare earth magnet manufacturing but the most common is the fluidized bed type shown schematically below:

Fluidized Bed.png


Schematic of fluidized bed jet milling system

Using my experience of rare earth magnet manufacturing (beginning in 1979!) and best quality systems practices we populate the 4 sections of the REassure™ template as shown below:

REassure™ template.png


Example of REassure™ template

These are the areas of control and documentation that the supplier audit targets for evidence and verification. Any specific process settings and product control values are determined using DFMEA and PFEMA tools and are normally detailed on control charts by the supplier.

The degree to which REassure™ is applied depends entirely on your tolerance of acceptable risk combined with the severity that an out of requirement magnet component causes in your application and at your customer.

JOC LLC can apply the REassure™ tool ranging from a basic desk audit to a multi-day on-site supplier audit.  In all cases a full report and recommended areas for improvement will be provided.  Our goal is to verify that the necessary manufacturing process control systems and methods are embedded and practiced at your supplier to assure the supplied magnetic products meet your requirements 100% of the time.


From: John Ormerod, Principal at JOC LLC

Previous: No Information

Next: Why are magnets disconnected from each other?